Last season we started with two new bee hives and lost both in the late fall early winter. Details here. After a long quiet bee-less winter, we now have bees again!

The plan for this year was to buy a single package of bees, since we had hives, comb, and even honey we chose a package over a nuc. For the other hive I spent the money, less actually, on a pre-built swarm trap in hopes we could catch a “free” swarm. More on that later. We purposely bought a package from a local apiary with a late season delivery in mid-may. The hope was with the delivery during full bloom and the left over honey we would need to feed the new package less.

So delivery day came and I was off to meet a guy with a trailer full of bees in a random parking lot. Felt a little like we were doing a secret deal, but it is all on the up and up – I swear. The interesting part was even though we had this late date, it was cold and rainy. Like 45 degrees cold. Being new I asked the guy about installing the package in the bad weather and he says “well they install them in the snow up north” and went back to his delivery of bees. Good enough for me, I guess.

A quick check of the weather showed it would stop raining late afternoon and might make it into the mid 50’s. I took the bees home and sprayed them with a 1:1 sugar solution to make sure they were feed and waited for the rain to stop.

One winter project was to build a true hive stand and to relocate the bees to a sunnier location. Both of these were a plan to reduce the hive beetle infestation. The new hive stand was copied from many found on the internet and consisted of two 2X6’s screwed to spacers about 11 inches apart. Last year the hives sat on these same boards laying flat, which didn’t allow for proper airflow under the hive and through the screened bottom board. So better ventilation and early morning sunshine – check! Since everything here is on a hill, a couple of cinder blocks were called into service to level the stand, plus get it off the wet ground.

I laid out the items I needed for the install on the hive stand before getting on my bee suit. Something about “shaking” a couple thousand bees around called for a little protection. In this picture you can see my hive tool, a spray bottle of sugar water, the hive components, and the package of bees. The two wooden shims are used to level an internal feeder.

Here is where I wish I had more pictures, but due to the bee suit and crappy weather I moved quickly to finish the job. First I sprayed the bees with sugar water to calm them and make them busy cleaning themselves. Next while holding the queen cage tab, I removed the can of sugar syrup shipped with the bees and then removed the queen cage. Checked the queen was alive and well before placing her cage between two frames with the screen facing so the other bees could still see and feed her. Then the fun part, I turned the package upside down and “gently” shook the bees out and into the hive between a couple of frames. I know there are a lot of folks online now saying this is too rough on the bees or not the way to do it. In this case due to cold weather and impending rain I wanted as many as the bees as possible inside the hive and closed up so I went old school rough! After closing up the hive, I placed the package out front in hopes the last few would find there way inside.



Swarm trap update:
While the trap has been out since the first of April there had been little activity until around the first of May. While on most sunny days we see a handful of bees coming and going, these are most likely scouts attracted by the smell of the frames and the swarm trap lure. I keeping looking for A LOT of bees or at least a few bringing pollen into the trap. The weather really hasnt been great, so we are hoping the next week of warmer weather being promised will cause a swarm to find it’s way to our trap. 🙂